The burner must therefore only be operated at minimum load and in intervals of 1-2 minutes for the first hours. When heated the water vaporises and expands which might cause fissures and cracks in the refractory. This is because the new refractory still contains a small amount of water. It might be necessary to perform a number of start/stop sequences to reduce the lighten-up rate.Īt the commissioning start-up of the boiler and after any repair work of the refractory, it is very important to further reduce the lighting-up rate. Chapter_7-16 Digital Indicator UT-150ģ1.When the boiler is started, the lighten-up rate of the boiler must not be accelerated too much as this might cause an unnecessary over strain of the boiler material by quick and uneven temperature rises. Chapter_7-9 Temperature Indicator UM-330ģ1. Chapter_7-5 Pressure transmitter EJA-110Ģ7. Chapter_7-4 Pressure controller UT-420Ģ3.
Chapter_3-3 Action on faluts during operationĢ2. Chapter_3 Operational guidance and emergency procedureġ2. Chapter_2-28 Function of alarm and safety deviceġ1. Chapter_2-26 Pressure control system of IGSġ0. Chapter_2-10 Piping and operation diagramĥ. INERT GAS SYSTEM ContentsMessrs.: Sumitomo Heavy Industries Marine & Engineering Co., Ltd.ģ. 2463 Instruction manual for IGS, Mission OL boiler, AV-6N EconomizerįINAL DOCUMENTS for Mission OL BoilerContentsĭATA SHEETS FOR BOILER AND STEAM/WATER SYSTEMĭATA SHEETS FOR BURNER, FAN AND OIL SYSTEMĮLECTRIC DRAWINGS FOR BOILER CONTROL PANEL It is intended for steam or hot water production, the oil and gas-fired Aalborg OM is supplied as a vertical, pre-assembled boiler unit with both smoke tubes and pin tubes.
Aalborg Industries A/S is the world's leading supplier of marine boilers. I x mission 01 35wo t 1 k mission n 1600116w is^ dnv. Dim (DN) Application Type Datasheet or draw-ing Composite boiler (Qty. As '1C2' and '2C2' for boiler 1 and 2 respectively.
0 kommentar(er)
